Search the Community

Showing results for tags '60hz'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. Hi all, I've run into an unexpected problem. Issue It seems that when I use both scope channels within the same circuit (at least for this circuit) I get tons of 60Hz noise and its harmonics. Using a single channel does not generate this kind of noise. Setup I am using a 3 channel DC supply plugged into 60hz wall power that feeds my breadboard circuit in two areas. My breadboard circuit is a simple non-inverting op-amp whose input signal comes from a constant current source excited thermistor. The gain is ~ 30 V/V. I'm using the Analog Discovery 2. Details Normally, I've been using the either channel to check my pre or post-amplified signal. This single channel behaves normally. Nice low frequency temperature response from my thermistor. However, upon adding the other channel to look at the opposite end of my op-amp circuit, I get tons of 60Hz, 120Hz, etc. garbage. Advice? Regards, Eric