Search the Community

Showing results for tags 'canbus'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Test and Measurement
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 3 results

  1. I am going through UG585 document and trying to understand the formulas for the can bus baud rate. I am using the example from SDK (xcanps_intr_example). I am trying to understand how they are arriving at those numbers. Ultimately I would like to set up the baud rate at 1 megabit per second. /* * The Baud Rate Prescaler Register (BRPR) and Bit Timing Register (BTR) * are setup such that CAN baud rate equals 40Kbps, assuming that the * the CAN clock is 24MHz. The user needs to modify these values based on * the desired baud rate and the CAN clock frequency. For m
  2. opethmc

    DMC60c CAN Bus

    I am looking at the DMC60c CAN protocol guide and also the software API reference manual. What are the API numbers needed in the CAN message to communicate with the DMC60c. For example if I wanted to send a voltage command using the function driveVoltage, what should go in the API field (Byte 1) of the message identifier? Thanks, matt
  3. Hello, I have the Zynq 7000 board (Z-7010). I'm trying to build a Vhdl Program that receives a Canbus Frame. I saw in the tutorial that There is a builtin Canbus Controller, where is the canbus Interface?should i use the standard interface? Is there a simple example of such a program? - I use the 2017.1 Vivado and the Z-7010 Board. Thanks.