Jonsm

Members
  • Content Count

    2
  • Joined

  • Last visited

About Jonsm

  • Rank
    Newbie

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Nevermind! The USB cable was broken. I tried another and it worked.
  2. Hello, I am new to FPGA programming so I am trying to do the Basys 3 Getting Started tutorial from the wiki. However, when I try to open a hardware target in Vivado, I get the error: [Labtoolstcl 44-26] No hardware targets exist on the server [TCP:localhost:3121] Check to make sure the cable targets connected to this machine are properly connected and powered up, then use the disconnect_hw_server and connect_hw_server commands to re-register the hardware targets. The cables seem to be properly connected and the board is on. I followed the commands above and get the same error. I uninstalled and installed the digilent drivers several times but I still get the error. I downloaded Adept and the Basys 3 also doesn't show up under the device manager. My computer must not be detecting it but I'm not sure why. Thanks.