Everything posted by adithya76
Hi @JColvin Thanks for your reply. I am connecting through USB. After I posted earlier, I found that LabVIEW runtime fails to install for some reason (which had been successful previously and I was able to deploy the code BBB). This is the log OS Version: 8.4 CPU: Systemd Version: Has Internet Access: True Device Type: BeagleBone Black Connecting to target... Successfully connected to target. Successfully connected to the target. Target configuration updated. OS Version: 8.4 CPU: Systemd Version: Has Internet Access: True Device Type: BeagleBone Black No led_aging.sh scritp on target. Adding MakerHub feed... MakerHub Feed Already Exists Updating package index. This may take over 30 seconds depending on your internet speed... Ign http://feeds.labviewmakerhub.com binary/ InRelease Hit http://repos.rcn-ee.com jessie InRelease Ign http://feeds.labviewmakerhub.com binary/ Release.gpg Get:1 http://security.debian.org jessie/updates InRelease [44.9 kB] Ign http://security.debian.org jessie/updates InRelease Ign http://feeds.labviewmakerhub.com binary/ Release Ign http://repos.rcn-ee.com jessie InRelease Installing LabVIEW... Reading package lists... Checking target status... Installation failed. If this is the first time the installation has failed try again. If this error persists search, then post on the LabVIEW MakerHub forumsat labviewmakerhub.com/forums/linx. Target configuration updated. OS Version: 8.4 CPU: Systemd Version: Has Internet Access: True Device Type: BeagleBone Black It looks like things are unraveling which I am not able to figure out why.
Hi, Following the tutorials, I was able to install labview and linx. I had developed a program, and it was running quite well. But whenever I turn my computer off and on, beaglebone fails to connect. In the sense, I'm able to connect to the beaglebone through the Linx target configuration and I can even ssh using putty. But when I go into my project and try and run the VI on BBB, it regularly pops up the error saying "Failed to connect to Target". I have vigourosly searched the entire linx forum for such an issue. And have tried everything that has been suggested but to no avail. My question is how can it show connectivity in Target configuration, but fail to connect inside the project when I try to run the VI? I am seeing another peculiar event too. Sometimes, if I reinstall the software using Target Configuration, BBB connects perfectly temporarily. And it disconnects pretty soon. But the process of reinstalling also does not happen regularly. It often fails and the message that says to post in the forum pops up. I have viewed the log and wasn't able to find anything substantial. I have tried manual installation and it fails too. This irregularity in connection is something that bothers me. I am not able to figure out a pattern too. When it connects, it is perfect.
Hi, I am having the same issue with I can ping beaglebone and even use Putty, however, LiNX does not connect to BBB. I have followed the steps in the video and the solutions provided in this thread. But I am getting the same error. Is there anything else that I could do? thanks, adi