hiketen

Members
  • Content Count

    3
  • Joined

  • Last visited

About hiketen

  • Rank
    Newbie

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. I get the following error in the boot log when I boot the board as in step (4) of secton (5.2) RAMDISK: Couldn't find valid RAM disk image starting at 0. The complete boot log follows : U-Boot 2014.01-00005-gc29bed9 (May 21 2015 - 10:27:14) I2C: ready Memory: ECC disabled DRAM: 512 MiB MMC: zynq_sdhci: 0 SF: Detected S25FL128S_64K with page size 256 Bytes, erase size 64 KiB, total 16 MiB *** Warning - bad CRC, using default environment In: serial Out: serial Err: serial Net: Gem.e000b000 Hit any key to stop autoboot: 3 2 1 0 Device: zynq_sdhci Manufacturer ID: 27 OEM: 5048 N
  2. I dropped the other arguments as per your suggestion and it compiles with no errors! Thank You!
  3. I am following the instructions in the Embedded Linux Hands-on Tutorial and got stuck at step #3 in section 4.2. The step #2 is successful with the following output : make ARCH=arm CROSS_COMPILE=arm-xilinx-linux-gnueabi- xilinx_zynq_defconfig HOSTCC scripts/basic/fixdep HOSTCC scripts/kconfig/conf.o SHIPPED scripts/kconfig/zconf.tab.c SHIPPED scripts/kconfig/zconf.lex.c SHIPPED scripts/kconfig/zconf.hash.c HOSTCC scripts/kconfig/zconf.tab.o HOSTLD scripts/kconfig/conf # # configuration written to .config # The command in step #3 gives the following error : make ARCH=arm CROS