sdm

Members
  • Content Count

    2
  • Joined

  • Last visited

  1. sdm

    FMC-CE Breaks JTAG Chain

    Agreed. Thanks for that explanation. I was using a newly configured carrier card (ZC706) and this new FMC card together, and assumed it was the FMC card causing the JTAG issues based on what I saw with TDI/TDO on the scematic. It turns out that the ZC706 JTAG configuration switch (SW4) was configured incorrectly. Thanks!
  2. sdm

    FMC-CE Breaks JTAG Chain

    I've got the FMC-CE board plugged into a ZC706, and when I try to load open the Hardware Manager in Vivado, it finds my HW target, but there are no devices found. After a little digging I found that there is an FMC design rule that if you don't use the JTAG chain you need to tie the FMC TDI pin to the TDO pin. Looking at the schematic, this isn't done on the FMC-CE board. Both of these FMC pins (D30, D31) are disconnected. What's the best way to work around this to enable JTAG debug when this board is installed?