suggi

Members
  • Content Count

    3
  • Joined

  • Last visited

About suggi

  • Rank
    Newbie

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hi I'm planning to use the pmod ISNS20 for a project. I want to interface it with nexys4ddr board. The pmod isns20 has 2 interfaces: input : hall effect sensor's input terminals IP+ and IP-; output: ADC's output terminals: SDO; I'm familiar with the usage of the output interface with the nexys4 ddr using the SPI protocol. However, I'm not familiar with the input interface. I want to know if a sense resistor has to be used across the IP+ and IP- terminals? If so, what would be the equation of current? If no sense resistor is used, how to connect the terminals IP+ and IP- to the circuit? And again what is the equation of current being measured? I have seen the datasheets for both adc and hall effect sensor. Did not find any info on how to connect the IP+ and IP- terminals. Any help on this is highly appreciated. Thanks
  2. Hi I'm also planning to use the pmos ISNS20 for a project. I want to interface it with nexys4ddr board. The pmod isns20 has 2 interfaces: input : hall effect sensor's input terminals IP+ and IP-; output: ADC's output terminals: SDO; I'm familiar with the usage of the output interface with the nexys4 ddr using the SPI protocol. However, I'm not familiar with the input interface. I want to know if a sense resistor has to be used across the IP+ and IP- terminals? If so, what would be the equation of current? If no sense resistor is used, how to connect the terminals IP+ and IP- to the circuit? And again what is the equation of current being measured? I have seen the datasheets for both adc and hall effect sensor. Did not find any info on how to connect the IP+ and IP- terminals.