rana_20

Members
  • Content Count

    6
  • Joined

  • Last visited

About rana_20

  • Rank
    Newbie

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hi, I was wondering what setup I need to do (tools, software I need) to do run-time monitoring of power consumption (using I2C interface). I currently use xadc and ilacore to monitor internal signals and temperature of pga and log their values using tcl command in vivid hardware manager. Any suggestions ? Thanks Rana
  2. Hi, I have a genesys2 board, I am trying to read power consumption of fpga using the embedded power monitor indicated in the reference manual. However, I do not know how to access the recorded values by the power monitor and log them into .csv file (what are the required tools, what should I be looking at). I also would like to sample power consumption values, along with temperature and other internal signal values. For temperature I use xadc, for internal signals monitoring I use ilacore and I read both using hardware manager, I was wondering how to sample power consumption simultane
  3. Hi, I have a genesys2 board, I am trying to read power consumption of fpga using the embedded power monitor indicated in the reference manual. However, I do not know how to access the recorded values by the power monitor and log them into .csv file. I also would like to sample power consumption values, along with temperature and other internal signal values. For temperature I use xadc, for internal signals monitoring I use ilacore, I was wondering how to sample power consumption simultaneously with the other measurements. Thanks Rana
  4. Hi, -I am using hardware manager in vivado, how can I capture values of the power consumption on genesys2 board (both power consumption in fpga and in the whole board') and save the sampled values to a .csv file ? -I also capture internal design signals using Ila cores and also use XADC to monitor approximate temperature of the design and I would like to sample temperature, power and internal design signals at the same time, any suggestions ? I am using genesys2 board with kintex-7 fpga, Thanks a lot Rana