Regis Martins

Members
  • Content count

    27
  • Joined

  • Last visited

About Regis Martins

  • Rank
    Member
  • Birthday 02/06/1969

Contact Methods

  • Skype
    regisftm

Profile Information

  • Gender
    Male
  • Location
    Sorocaba - SP
  • Interests
    P4 Lang, Net monitoring
  1. Hello everyone! I just install a NetFPGA-SUME and I am not sure if it is ok. I followed the getting started guide in https://github.com/NetFPGA/NetFPGA-SUME-public/wiki/Getting-Started-Guide, however, something went wrong apparently... In the Section IV: NetFPGA-SUME First Power Up, I followed the steps, but, after turning on the power switch (SW1) it says I should see Power LED (LD10) and DONE LED (LD4) turn on immediately, however I only see the Power LED (LD10) on... in red. The DONE LED is off. In the next step... When I connect USB to my computer I can see a new USB serial device attached [ 13.194737] usb 3-1: FTDI USB Serial Device converter now attached to ttyUSB1 However, when I try to connect, terminal does not respond (I'm using putty to connect /dev/ttyUSB1). Any clue about what is happening? I tried it with the card connect to my server PCI and also stand alone. Also connecting 2x4 and 2x3 PCI express auxiliary power connectors. Thank you in advaned!