Hi, I'm using Digilent's XUP USB-JTAG Programming Cable to program 'Z-turn board' which uses Xilinx Zynq-7000(http://www.myirtech.com/list.asp?id=502). There was no problem when I programed Bitstream or BBRAM through JTAG, but when I tried to program eFUSE Xilinx Vivado threw an error - ERROR: [Labtools 27-3277] jsn-DLC9LP-00000000000000 cable is not supported for EFUSE programming. Please use a Xilinx PCUSB2 DLC10 or approved Digilent cable I think my cable is approved one. Does anyone have any solution for this? Thank you in advance.