lakshmis

Members
  • Content Count

    7
  • Joined

  • Last visited

About lakshmis

  • Rank
    Newbie

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. How to find out a particular IP like for example Watchdog timer (SP805)is supported by which board and which processor i want to know these details like may be used in Raspberry pi or Beagle board please some one respond to this immediately
  2. Hi, Am trying to validate I2C peripheral on xilinx zynq zc702 evaluation board in u-boot. When am trying to run the command like i2c probe and i2c write am facing the issue like i2c commands are not known. Please can someone tell me how to enable these commands to use it in u-boot
  3. Hi, Please can anyone tell how to connect jtag to the zynq board zc702 evaluation board and work on it. Any video which shows the connections and working on it as am new to this
  4. Am trying to load uboot(Xilinx) and bring the Zynq zc702 board up from sdcard. When i tried to connect to the board through the picocom command am able to enter till terminal ready after that i have not seen any logs related to uboot and the terminal is getting stuck and searched over the internet for the solution but still am not sure why it's happening like this. Please can i get some info on this please can some one show me the connections of bringing up the board using digilent J-TAG cable because when i give the command "connect arm hw" am getting cable error in XMD console
  5. Am trying to load uboot(Xilinx) and bring the Zynq zc702 board up from sdcard. When i tried to connect to the board through the picocom command am able to enter till terminal ready after that i have not seen any logs related to uboot and the terminal is getting stuck and searched over the internet for the solution but still am not sure why it's happening like this. Please can i get some info on this please can some one show me the connections of bringing up the board using digilent J-TAG cable because when i give the command "connect arm hw" am getting cable error in XMD console
  6. Thank You Dan. The Error was resolved and am able to generate .bin.
  7. Hi , I have tried to find the fix for this and gone through some information over the internet but it was not solved Please can someone respond to the below error why it occurs exactly engineer@mcinhvendes14:~/lakshmi/Evalboard_code/u-boot-xlnx$ make ARCH=arm CROSS_COMPILE=arm-xilinx-linux-gnueabi- make: arm-xilinx-linux-gnueabi-gcc: Command not found /bin/sh: 1: arm-xilinx-linux-gnueabi-gcc: not found dirname: missing operand Try 'dirname --help' for more information. scripts/kconfig/conf --silentoldconfig Kconfig CHK include/config.h GEN include/autoconf.mk /bin/sh: 1: arm-xilinx-linux-gnueabi-gcc: not found make[1]: *** [include/autoconf.mk] Error 1 make: *** No rule to make target `include/config/auto.conf', needed by `include/config/uboot.release'. Stop.