RobG

​I just downloaded 3.0.25, installed WaveForms and the driver, and it now works as expected!

I got the latest download, digilent.waveforms_v3.0.17.dmg, and installed both, the driver and the app. When I launch WFs, I get "No device detected" message even though my AD is connected. WF runs fine in DEMO mode. Any suggestions?

The bit rate was 250k (DMX.)

One more thing regarding UART interpreter. In my setup, 0x00 is interpreted as BREAK most of the time. When I set the baud rate to ~1% less than it is, everything works fine. Is the bit test performed at the beginning or in the middle of the bit?

Could you add another signal to SPI interpreter? It would be nice to have both data lines (MISO and MOSI) in the single interpreter instead of two. Also, how about one more for things like R/S or D/C. I know I can add it as a separate signal, but if it was part of the group, it could control things like the color of interpreted data (so for example data bytes could be green and control bytes yellow.) Is that possible at all? Finally, it would be great to have a row for skipped bit when 9bit SPI is used (this bit is sometimes used for D/C) and and the ability for that bit to control the color (as above.)

Are there any plans to add more interpreters? Can users create their own?