Stewart Ritchie

Members
  • Content Count

    2
  • Joined

  • Last visited

  1. I have subsequently programmed the board with my new firmware which was successfully verified. This leads me to conclude that the demo firmware on the website is different to the firmware programmed on the evaluation board. Either I have a board with out-of-date firmware or the website has out-of-date firmware. Regards,
  2. Hi, I have just received a CMOS S6 evaluation board (410-282P-KIT). Before I program it with my development code I wanted to verify my setup is working Ok. I am using Xilinx 14.7 on a Windows 7 PC. I have loaded iMPACT and successfully initialised the scan chain. I assigned the demo bit file to the FPGA and the demo mcs file to the flash device. When I ask it to iMPACT to verify the contents of the flash memory it fails at address 0. The iMPACT console output is displayed below. INFO:iMPACT - Current time: 11/07/2016 13:18:16 PROGRESS_START - Starting Operation. Maximum TCK operating frequency for this device chain: 25000000. Validating chain... Boundary-scan chain validated successfully. '1': IDCODE is '012018' (in hex). '1': ID Check passed. '1': IDCODE is '012018' (in hex). '1': ID Check passed. '1': Reading device contents... Failed at address, 0 '1': Verification Terminated PROGRESS_END - End Operation. Elapsed time = 1 sec. Is it possible to verify the PROM contents and if so what am I doing wrong? Regards, Stewart.