cvip

I am using ZyboZ7 board to learn how to program HLS. I followed the document "ZYBO Z7 & Pcam 5C HLS Video Workshop". I followed the document. After I opened SDK and clicked green "Run" bottom. I got the error below. The connection seems ok, the PGOOD is red on. I don't know what happened here. Thanks. Mike Error while launching program: Could not find ARM device on the board for connection 'Local'. Check if the target is in: 1. Split JTAG - No operations are possible with ARM DAP. 2. Non JTAG bootmode - Bootrom may need time to enable DAP. Please try again. Troubleshooting hints: 1. Check whether board is connected to system properly. 1. In case of zynq board, check whether Digilent/Xilinx cable switch settings are correct. 1. If you are using Xilinx Platform Cable USB, ensure that status LED is green. Could not find ARM device on the board for connection 'Local'. Check if the target is in: 1. Split JTAG - No operations are possible with ARM DAP. 2. Non JTAG bootmode - Bootrom may need time to enable DAP. Please try again. Troubleshooting hints: 1. Check whether board is connected to system properly. 1. In case of zynq board, check whether Digilent/Xilinx cable switch settings are correct. 1. If you are using Xilinx Platform Cable USB, ensure that status LED is green.