Jump to content

memo

Members
  • Posts

    3
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

memo's Achievements

Newbie

Newbie (1/4)

0

Reputation

  1. memo

    Arty S7 XADC Pins

    Thank you @JColvin!
  2. memo

    Arty S7 XADC Pins

    Hi @JColvin Thank you so much for your response, I really appreciate it :) I was able to get it work! It seems that the pins I routed to, B13 and A13, are the following: B13 is the header pin "A0" on the board, and when I feed it a voltage between 0-3.3V, my digital output value changed correspondingly. A13 seems to be already grounded on the board, so I didn't need to worry about it. Thank you so much for your help!
  3. memo

    Arty S7 XADC Pins

    Hi there, I hope everyone is safe and doing well, and thank you checking out my forum post; I would greatly appreciate your help :D I was trying to get the XADC working on the Arty S7; I tried setting it up using the XADC IP in Vivado, and while I think I may have properly used the signals the IP has instantiated for me, I'm just a little confused which pins to connect the analog inputs to. To be more specific, the IP created two signals "vauxp0" and "vauxn0" which I think are the analog inputs: vauxp0 => Vaux0_v_p, vauxn0 => Vaux0_v_n, I suspect these need to be connected to analog input header pins on the Arty S7, and I found two pins called "Vaux0_v_p" and "Vaux0_v_n" in the .xdc constraint file which I connected to the signals above: ## ChipKit Single Ended Analog Inputs ## NOTE: The ck_an_p pins can be used as single ended analog inputs with voltages from 0-3.3V (Chipkit Analog pins A0-A5). ## These signals should only be connected to the XADC core. When using these pins as digital I/O, use pins ck_io[14-19]. set_property -dict { PACKAGE_PIN B13 IOSTANDARD LVCMOS33 } [get_ports { Vaux0_v_p }]; #IO_L1P_T0_AD0P_15 Sch=ck_an_p[0] set_property -dict { PACKAGE_PIN A13 IOSTANDARD LVCMOS33 } [get_ports { Vaux0_v_n }]; #IO_L1N_T0_AD0N_15 Sch=ck_an_n[0] My questions were: 1) Have I connected the IP-generated input signals to the right pins from the .xdc file? 2) If so, which header pins are these on the Arty S7 board? That is, where in the board should I connect my external analog signal to? Thank you all very much!
×
×
  • Create New...