canisio

Newcomers
  • Content Count

    2
  • Joined

  • Last visited

  1. Thank you for your explanation @JColvin . I’ve used XGpioPS with MIO50 and MIO51. So if I just want to use J7 as GPIO (no fancy Pmod), all I need to do is to activate them in the Zynq IP (vivado) and then use the XGpioPS drivers? Thanks again.
  2. Hello all, I'd like to connect a Pmod peripheral to the JF connector of Zybo z7-20, however, looks like the board files do not include this interface. When I open a new block design on Vivado, the "board" tab shows only JA through JE connectors. Do I have to manually map it? Maybe use the master xdc file? I'm using Vivado 2018.2 and the "new" board files from github. Thanks!