Babu

Finally, I solved this problem. HS3 detect Artix A7. :) Please see the attached image for solution. and also refer page no. 2 in https://reference.digilentinc.com/_media/jtag_hs3:jtag-hs3_rm.pdf Main problem was very difficult to identify which pin is 1,2 and so on in JTAG-HS3 in reference manual doesn't represent it. @JColvin In HS2 pin details clearly mentioned https://store.digilentinc.com/jtag-hs2-programming-cable/ but HS3 doesn't mention https://store.digilentinc.com/jtag-hs3-programming-cable/ I spend to much time for solve it. forum not bad. Dear Digilent Please Update in reference manual otherwise misunderstood and waste of time. @zygot who responsible for this? ------------------------------------------------------------------------------------------------------------------------------------------------- Please accept my solution and give Kudos. ------------------------------------------------------------------------------------------------------------------------------------------------

@zygot Yes, I able to configure Mimas A7 using the HS2 cable. Please see the attached image file How HS3 JTAG connect with Mimas A7. Where to find jtscdvlist.txt what are the lines to be add on that file. I believe solution is there for HS3 either firmware or circuit design. for reference please the link for schematic of Mimas A7 board https://numato.com/help/wp-content/uploads/2018/06/MimasA7_V3.1_Sch.pdf Digilent Team, Please support for HS3 either changes in firmware or circuit required? because Digilent cable is expensive.

@JColvin I checked with Digilent Adept, Why HS3 doesn't detect with Artix A7? I verified with HS2 and Artix A7 FGPA its detected and also I verified HS3 with Kintex KC705 EVM Its detected. I checked HS2 and HS3 voltage i.e 3.3v. Is possible to exchange the HS3? I need HS2. I purchased by one of the distributor RS component. Please give the solution for HS3 with Artix A7. Is any one work with it?

Hi @JColvin I am using https://numato.com/product/mimas-a7-artix-7-fpga-development-board/ and also I tried with Adept software I am using JTAG HS3 cable. Thanks , Babu

Digilent HS3 cable doesn't detect Artix A7 FPGA.