Erick

Members
  • Content Count

    5
  • Joined

  • Last visited

About Erick

  • Rank
    Newbie

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hello, I am looking for an online training course (does not have to be free) that utilizes the Arty Z7 development board and Vivado Design Suite in VHDL. If anyone has a good suggestion as to a course that is available I would greatly appreciate it. I am mostly looking for a beginner course and am fairly new to FPGA Design. Thank you.
  2. Hello, I am very new to fpgas and vivado but have been playing around with the Arty S7 board for a little while now. I have used the pushbutton/switches and LED GPIOs pretty easily with the block diagram design and controlling them in SDK. I am having difficulty figuring out how to use another pin on the S7 board (ie pin L17) as an input. Do I need to set this up with AXI GPIO, or can I just create an interface port with this pin? How do I configure this with the constraint file and then ultimately how do I initialize it in SDK? Thanks for any information.
  3. Erick

    Arty S7 Timer caputre

    Hi, I am trying to setup a timer capture on my Arty S7 board that measures the pulse width (high trigger) of an input signal and then access that value in SDK (Vitis) where I can send it out a UART. I am having a bit of difficulty with this and was hoping someone could point me to some examples. I am primarily using the block diagram design in Vivado. Any help on this would be very much appreciated. Thanks
  4. Hello, I am sure this is an extremely noob question but I am just getting started with FPGAs... I created a simple ROM module in Verilog (2 bit address "addr" and 8 bit data output "data") I have also created a block design microblaze project with a uart that I have been able to send things out of in the past. My question would be how do I access the ROM using Vitis? I would like to send the data in each ROM address out of the UART, but I am not understanding how to do this in Vitis. Thanks for any help.
  5. Erick

    Arty S7 I2C example

    Hello, I am looking for an example on how to use I2C on the Arty S7 board or similar. Specifically with a block diagram example as I am not proficient in VHDL or Verilog. My main goal is to to interface with an external ADC that uses the I2C protocol. Thanks for any information