John Zsori

Newcomers
  • Content Count

    5
  • Joined

  • Last visited

  1. John Zsori

    jtag-hs3

    I may have misinterpreted your dwg. I was looking for the info looking into the 2X7 receptacle end so that I could make a template checking for clearances on my layout. However, looking at my jpg above I measure 0.650 X 1.285 overall which is pretty close to what you show. Looking into the receptacle end I measure 0.650 wide X 0.290 thick. I think we are basically in agreement. Thanks again.
  2. John Zsori

    jtag-hs3

    This is the part. Header is 2X7 2 MM X 2 MM pitch.
  3. John Zsori

    jtag-hs3

    FYI - client sent me the actual part. My measurements indicate that the dimensions you sent are almost 2X the actual part.
  4. John Zsori

    jtag-hs3

    Thank you - much appreciated.
  5. John Zsori

    jtag-hs3

    I am an independent PCB layout designer and am working on a new design where the client will be using this part. It will be plugging into a 2X7 shrouded header. I need to make sure that there will be enough clearance around the header so that the jtag-hs3 doesn't interfere with anything. Do you have any mechanical details you can send me on this? I cannot seem to find anything online except for the general datasheet stuff. Thanks