Dareamol

Newcomers
  • Content Count

    6
  • Joined

  • Last visited

About Dareamol

  • Rank
    Newbie

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hello, We are trying to generate the SPI protocols signals from the Zybo-Z710 board, which uses Zynq-7000 SoC. Since, the PS section of the chip contains two SPI modules. Can anyone tells me the procedure for activating the SPI line inside the PS. I want to use this SPI lines to transfer data and provide control to the another module. Thanks AMOL
  2. Thanks for the reply. So, does that mean that the PMOD input/outputs will be working in the open drain config. by default. Can you tell me how we can enable those pull-up/pull-down resistors. Regards Amol
  3. We are using PL section of the Zynq7000 to transfer data to another module b y creating a SPI IP Inside the PL. We want to know that the PMOD pins availvalble on the Zybo-Z710 board are using open drain or push-pull configuration ? Do they have something like a internal pull-up resistor ? Please let me know.. Regards Amol
  4. Sure. I dont know which file you are talking about but, this is .xpr file which you can open and check in Vivado. Regards Amol test1_PS.xpr
  5. I am trying to run the "Hello world" program on my Zynq 7000 family board. The issue which is happening is i am not able to see the output of the program on my Terminal. I am using the SDK terminal for seeing the output. I have already gone through some videos from xilinx on SDK and i am following the same steps as they did. One day before, it was working fine but, i am really unable to figure out what is the issue now. I am a kind of a newbee in using Viavado and SDK, so it will be really great if some one can help me out. I am using Vivado 2019.1. So these are the steps which i am following: 1) Created a block diagram in Vivado and generated the bitstream. We can see that i am using UART1 and GPIO in peripherals. 2) Then I launched SDK from Viavdo and Created a new Application project. Then i used the "Hello world" template and created the BSP. 3) I created a "Run configuration", connected my terminal, Programmed my FPGA and then Launched the program on Hardware. Please let me know if any other information is needed. Thanks Amol
  6. Can anyone suggest me how to program the UART/USB available in the ZYBO Z7 board and use it as a port to feed the data from the PC/SERVER ?