• Content Count

  • Joined

  • Last visited

About andylb

  • Rank

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hi @labviewkozou, I was able to install LINX on the Raspberry PI 3 B+. I have just created a post on this forum with the procedure that I used : Cheers, Andy.
  2. Hi everyone, LINX can be installed on the Raspberry Pi 4. The LINX 3.0 Target Manual Install Process ( did not work due to changes in the latest version of Raspbian. Here is the procedure that I used to install LINX. The procedure also works on the Raspberry Pi 2B, Pi 3A+, Pi 3B and Pi 3B+ running Raspbian Buster. 1. Setup the Raspberry Pi using the latest Raspbian Buster Image. 2. Change the default password for the Pi account on the Raspberry Pi. 3. Setup a WiFi or Ethernet connection from the Raspberry Pi to your router. 4. Enable SSH on the Raspberry Pi. 5. SSH into the Raspberry Pi or open a terminal window on the Raspberry Pi desktop. 6. Check that the Raspberry Pi can access the Internet by entering the command ping -c 4 7. Enter the commands shown in bold below. Note: The text may wrap due to the web browser window size. I recommend copying the text into a text editor to see the original formatting. The commands are in the attached file linx_install_commands.txt # Enable i2c and spi sudo raspi-config nonint do_i2c 0 sudo raspi-config nonint do_spi 0 # Update Raspbian sudo apt-get update sudo apt-get dist-upgrade -y # Install LINX sudo sh -c 'echo "deb [trusted=yes] binary/" >> /etc/apt/sources.list' sudo apt-get update sudo apt-get install -y lvrt-schroot # Move the nisysserver.service and labview.service files to the systemctl folder sudo mv /etc/systemd/system/ /lib/systemd/system sudo mv /etc/systemd/system/ /lib/systemd/system # link to the Raspberry PI device driver file sudo schroot -c labview -d /usr/lib -- ln -s # Enable the nisysserver.service and labview.service to start on boot sudo systemctl enable nisysserver.service sudo systemctl enable labview.service # Start the nisysserver.service and labview.service sudo systemctl start nisysserver.service sudo systemctl start labview.service You should now be able to connect to the Raspberry Pi from the LabVIEW Project Explorer. Cheers, Andy. linx_install_commands.txt
  3. Hi Everyone! Any plans for a new version of LINX for the Raspberry Pi? Cheers, Andy.