gtenaglia

Members
  • Content Count

    1
  • Joined

  • Last visited

  1. When using the scope from the Waveforms IDE, I can't get a visual of Channel 2. (Channel 1 works fine) I've tried using multiple USB ports and other computers. When I run calibration for the oscilloscope I get the following error message: "Check the connections!! The measured voltage on Oscilloscope Channel 2 is between: 30.269009276 V and 30.275477712 V. But it should be around: 0 V. It might be that the Arbitrary Waveform Generator 1 Offset is not calibrated correctly." I don't think the waveform is the issue, it reads as expected on channel 1. I could use some help.