• Content Count

  • Joined

  • Last visited

  1. Thank you so much @jpeyron, that works great! All of the examples I've seen use a third party terminal, do you know why this is? Is it even possible to control the ESP32 through the SDK Terminal? If so, what would it require? Thanks, Joe
  2. Hello, I am trying to run AT commands on an ESP32 pmod connected to a zedboard. Both switches on the ESP32 are in the off position. My hardware block diagram is attached. When I launch SDK and open a terminal to run the AT commands, they are echoed back to me, but I don't get any other of the expected responses i.e. "OK" for the command "AT". Is my hardware configuration correct? Should I be communicating with the Pmod through an alternative to the terminal in SDK? Thanks, Joe