Leaderboard


Popular Content

Showing content with the highest reputation on 03/22/16 in all areas

  1. 1 point
    DigilentStudio

    Temperature Probe

    Tejeshw Vardhan asked the following question on our YouTube channel: "i have designed a current and temperture probe using ACS712 and LM35. has anyone tried it??" Thank you for taking the time to discuss this project with him.
  2. 1 point
    Hey Shruthi, I believe the correct way to do this is by making a .txt or .csv file and then loading that into the XADC IP block under ANALOG Sim File Options on the basic tab. The formatting of these files is discussed on page 41-43 of the product guide linked below. http://www.xilinx.com/support/documentation/ip_documentation/xadc_wiz/v3_2/pg091-xadc-wiz.pdf I've never done this before but if you run into any walls post here again and we can help you figure this out! -Sam
  3. 1 point
    Hi Shruthi, 1) check http://www.xilinx.com/support/documentation/user_guides/ug480_7Series_XADC.pdf page 60 - table 4-4. The channel numbering is a little bit odd. 2) Not sure, as XADC is only available on 7-Series FPGAs. I guess it is for future chips, and I guess it only matters for simulation. 3) If you want to only read channel 6, yes. See figure 3-1 on page 36. Mike